View Single Post
      09-17-2008, 02:06 AM   #18
weez
Lieutenant
272
Rep
467
Posts

Drives: 2021 X3M Competition
Join Date: Apr 2008
Location: Arizona

iTrader: (0)

When I pulled my right side grill out, I cracked it
The other side I was more careful on and since I could use the other grill as a tab reference, I made sure and pulled it out one tab at a time.
Be careful not to drop a screw when putting the mustache on the bonnet. Because the screw wont fall to the ground through the engine compartment. The plastic under engine splash guard/wind deflector, covers the entire underside If you're lucky enough to see the screw dont try to use your magnetic screw finder, as the screws arent metal....ask me how I know
I ended up driving my car onto ramps, getting underneath and banging on the undertray to locate the screw. I was finally able to isolate the screw into a position that I could reach my had over and grab it. That ended up being a stone Did it again, and voila, got it.
A 5 minute job, turned into a 45 minute job
Appreciate 0