[baron95]

One more mod today. 5 min to lift the M2 (my first time lifting a G-series), 5 min to install the ZunSport lower oil cooler guard.

Tools used:

Dead blow hammer- to straighten the tabs that arrived completely bent. Just ponder them with wooden block.

10 mm socket - for the two tab bolts - they take very little torque.

1/16 drill - to do a pilot hole for the two self tappers.

Philips screwdriver.

My impression on this oil cooler hard….sturdy, high quality, easiest to install, good protection, but, I’m not sure abt those self tapping screws being enough. I thing I’ll add one or two more.

Pics or it didn’t happen….