[waky]

Hello!

I recently installed my SST dual valve controller on my axle back Dinan exhaust.

But I noticed that the difference in sound for it being fully open and closed wasn’t very noticeable. And I was wondering whether or not that is normal because I have seen videos of it done on g80s and it sounded very noticeable.

Thanks!

[mike@x-ph.com]

you can test it by looking inside the tips and checking if the valve is moving. if you cannot see the valve, put the car on a lift and check if the spring is moving

[waky]

I always assumed the valve flap worked since I could hear it switching everytime. Going to take off the tips to see if the flaps actually move since I can’t see it with them on. Hopefully I didn’t just assemble the valves on the exhaust wrong.

[waky]

Yea it turns out my flaps weren’t even open the whole time, guess I’m going to have to take it off and reinstall the valve flap.

[mike@x-ph.com]

let us know how it goes

[TJZ67201]

Did you get your flaps sorted out?

I have the SST single flap controller. If I were to get the Dinan exhaust, couldn’t I in theory use the single flap controller, since the second flag piggy-backs off of the OEM single flap connection?

[mike@x-ph.com]

Originally Posted by TJZ67201

Did you get your flaps sorted out?

I have the SST single flap controller. If I were to get the Dinan exhaust, couldn’t I in theory use the single flap controller, since the second flag piggy-backs off of the OEM single flap connection?

If it uses a Y harness for both flaps, then you could theoretically use a single-side controller.

I don't know if it's worth it, though, since MAD offers the same controller for 1 or 2 flaps for the same price, and SST is only $40 more for the two side controllers.

[waky]

Originally Posted by TJZ67201

Did you get your flaps sorted out?

I have the SST single flap controller. If I were to get the Dinan exhaust, couldn’t I in theory use the single flap controller, since the second flag piggy-backs off of the OEM single flap connection?

Nope, not yet. Been pretty busy so haven’t had the chance to reinstall them.

With the connector the Dinan exhaust comes with I would assume you will need a dual valve controller to controll both exhaust valves.