hydraulic floor jack stopped working

tadaska · 08-31-2018, 02:48 PM

It almost new, only used it 3 or four times. But this morning when I was pushing the handle up and down to lift the car it was only lifting a small amount each time - it would start lifting when the handle is almost all the way down. When I did lift the car it held it but after a while I think the car did drop a small amount.

There are instructions how to purge air but I don't understand what it wants me to do. I opened the rubber plug (in the red circle) gave it a few pumps and put the plug back in but now it's not working at all. There is a bit of lifting but it just goes straight back down.

Any ideas what I should do to try fix it?

overcoil · 08-31-2018, 03:03 PM

UncleWede · 08-31-2018, 03:04 PM

Big hanging curveball there, but you are supposed to twist the handle clockwise

The more likely issue is there isn't any fluid ever/left.

tadaska · 08-31-2018, 03:17 PM

Quote:

Originally Posted by ScottSinger

Thanks Scott, that worked. Easy when you have the right instructions. The videos I watch were useless.

08-31-2018, 02:48 PM	#1
tadaska Major 123 Rep 987 Posts Drives: 2006 E90 320D ES Join Date: May 2016 Location: Eastbourne iTrader: (0)	hydraulic floor jack stopped working It almost new, only used it 3 or four times. But this morning when I was pushing the handle up and down to lift the car it was only lifting a small amount each time - it would start lifting when the handle is almost all the way down. When I did lift the car it held it but after a while I think the car did drop a small amount. There are instructions how to purge air but I don't understand what it wants me to do. I opened the rubber plug (in the red circle) gave it a few pumps and put the plug back in but now it's not working at all. There is a bit of lifting but it just goes straight back down. Any ideas what I should do to try fix it?
	Appreciate 0 Tweet Quote

08-31-2018, 03:03 PM	#2
overcoil Major General 3123 Rep 5,582 Posts Drives: M235i 6spd Join Date: Dec 2013 Location: Mid-Atlantic iTrader: (0)
	Appreciate 1 tadaska122.50 Quote

08-31-2018, 03:04 PM	#3
UncleWede Long Time Admirer, First Time Owner 18449 Rep 9,428 Posts Drives: G01 X3 M40i Dark Graphite Join Date: Jun 2005 Location: Oxnard, CA iTrader: (0)	Big hanging curveball there, but you are supposed to twist the handle clockwise The more likely issue is there isn't any fluid ever/left.
	Appreciate 0 Quote