[BroDoze]

I don’t see this one a lot - usually it’s the TRE CS one.

I think I want just a slightly bigger spoiler than the CS one.

Can anybody with the ID-01 spoiler post some pics or videos?

Thanks!

[M_Power Rob]

Originally Posted by BroDoze

I don’t see this one a lot - usually it’s the TRE CS one.

I think I want just a slightly bigger spoiler than the CS one.

Can anybody with the ID-01 spoiler post some pics or videos?

Thanks!

I think there was a similar post but here ya go.

[BroDoze]

Thanks ^^ how is the fitment on the outside edges. Perfect curve?

[M_Power Rob]

Originally Posted by BroDoze

I don’t see this one a lot - usually it’s the TRE CS one.

I think I want just a slightly bigger spoiler than the CS one.

Can anybody with the ID-01 spoiler post some pics or videos?

Thanks!

You nay also want to consider the Unit 17 (this is on my M240 but its sane part as same decklid):

[M_Power Rob]

Originally Posted by BroDoze

Thanks ^^ how is the fitment on the outside edges. Perfect curve?

Fits perfect except for a couple millimeters short of the edge but not a deal breaker.

[g87Boricua24]

I just installed my TRE ID-01 this past weekend. Very easy install and I couldn’t be happier.

[CRUISE9153]

Here is a comparison of the TRE CS and ID-01 spoilers. CS is on top, ID-01 on the bottom. Both are pre- peg CF. CS is a similar but slightly smaller profile.

[JABCAT]

Here you go.

[Blacktemplar]

Some more on BSM…

.