[JABCAT]

Originally Posted by SpaceGhost

Anyone hear updates on when they will be producing sideskirts?

Last they told me was early next year.

[Whytar]

I have just ordered one of these lips for my G87. It was about $400 USD landed in Australia, but that represents so much better value than the CF items.
Given that it will most certainly be abused (mainly by my wife) I can replace this item 4 times for the same cost as a single CF unit.
Looking forward to receiving it.

[jessejericho]

If anyone at Aeroflow is listening - please make a V.2 that doesn't stick out so much and tapers in at the corners. Thanks!

[Whytar]

Originally Posted by JABCAT

Received the new splitter & swapped center sections. Putting both side by side on the ground the old center section definitely had a curve up in the center & did not sit flat on the ground. No such bend in the new piece.

That looks perfect now.
How difficult was it to remove (unstick) the old 3M tape to replace the center section?

[JABCAT]

Originally Posted by Whytar

That looks perfect now.
How difficult was it to remove (unstick) the old 3M tape to replace the center section?

Wasn't difficult really. My front end has ppf, so I had to be careful not to pull that away from the paint when removing the center section.

[Crazyotter]

Originally Posted by JABCAT

Placed an order for the Aeroflow Dynamics gloss black abs front splitter that was shown in another thread.

$199 plus free shipping. Ordered on Monday and it arrived in TX today via UPS. It comes in three sections, and each packaged nicely in plastic and then a fabric bag. Right off the bat, the quality feels 100% better than the Maxton pieces I previously ordered. The Maxton pieces were very flimsy, this splitter feels much more solid. The painted finish is also better than that on the Maxton pieces as well.

I'm going to take it to my Xpel shop to get ppf'd & will then install. At this point I'm very happy with this purchase & hope these guys come out with some matching side skirts.

Will post more pics once installed.

https://www.aeroflowdynamics.com/products/2023-2024-bmw-g87-m2-gt1-front-lip?_pos=2&_fid=bab4cf246&_ss=c

Do you need a lift or ramps to install?

[Digitalprty]

Originally Posted by Crazyotter

Do you need a lift or ramps to install?

Might depend on if you’re lowered or not. I’m lowered on MP HAS and had to drive up a short (2.5”) ramp.

[Crazyotter]

Originally Posted by Digitalprty

Might depend on if you’re lowered or not. I’m lowered on MP HAS and had to drive up a short (2.5”) ramp.

I’m stock so I guess I’ll be fine
Thanks for the quick response

[Crazyotter]

Just ordered mine. Well pre ordered, I guess all y’all got their inventory first

[Hybridizer]

Same excited to see how it looks on a frozen paint.

[Whytar]

Mine is sitting in my office (Ceramic Coated) waiting for the car to arrive. I think how nice it looks then remember it's about to be the leading edge of a fast moving car.

[BroDoze]

Originally Posted by Whytar

Mine is sitting in my office (Ceramic Coated) waiting for the car to arrive. I think how nice it looks then remember it's about to be the leading edge of a fast moving car.

Why didn't you PPF it if you're worried about it?

Little late now since you ceramic coated it.

Should've done PPF --> ceramic.

[Crazyotter]

Just checked and my pre-order will be shipped in mid March (hopefully)