[BradMX5]

Originally Posted by BIGW0RM

I havent done my install yet. But step 7 confuses me in the manual. What two bolts are not being reused from step 2?

2 of the 14 OEM 10mm bolts will not be put back in since MAD skid plate only uses 12 of the original 14 to mount.

My friend and I counted at least 5 times to make sure we weren't missing any holes and just chalked it up to they're not used with the new plate.

[BIGW0RM]

Originally Posted by BradMX5

2 of the 14 OEM 10mm bolts will not be put back in since MAD skid plate only uses 12 of the original 14 to mount.

My friend and I counted at least 5 times to make sure we weren't missing any holes and just chalked it up to they're not used with the new plate.

I understand two are not being reused. Im trying to figure out which two are not being used.

Is it the two bolts in those two recessed pockets on the factory plastic tray to the left and right of the jack support mount that are not reused?

[BradMX5]

Originally Posted by BIGW0RM

I understand two are not being reused. Im trying to figure out which two are not being used.

Is it the two bolts in those two recessed pockets on the factory plastic tray to the left and right of the jack support mount that are not reused?

Yes I believe it's those.
I was going to just put the screws back in under the plate but it was getting late and really didn't want to take things back off.

[Info@mad-us.com]

Originally Posted by BIGW0RM

I havent done my install yet. But step 7 confuses me in the manual. What two bolts are not being reused from step 2?

Bottom half of the oem plastic shield has 10 screws. Our shield uses 8 screws and 2 large bolts.

[DrBump471]

White arrows are where the 2 10mm screw holes will be covered up by the new guard.

Red arrows are where the stock 16mm bolts get removed and then replaced with MAD's 15mm bolts + spacers

Fixed picture with correct cover up location.

[sycd]

Does anyone have the size of the large washers and 15mm bolts? Need to order a new set.