|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
M47TU Cylinder head installing
|
|
01-14-2016, 01:44 PM | #1 |
Private
13
Rep 87
Posts |
M47TU Cylinder head installing
Hi guys,
My car is blowing oil everywhere and this is because of crankcase high pressure, something is seriously wrong. I will remove cylinder head this weekend, hopefully only gasket would be the problem, but assembling will take some time Anyway, I am checking manuals, looking for service manual and only one useful I've found online is this one (my car is E90, this is for E46 but this is same engine). http://workshop-manuals.com/bmw/3_se...7%29/page_565/ Hopefully this will be gasket to be replaced and in this case I am not planing to remove any valve, but still, some better manual would be nice to have before I start to work on this. So, my questions are : Anyone understand and can explain to me Tightening torque in this manual ? I really don't understand "Tightening torque 11 12 7AZ" for example. Anyone have some better manual ? Someone did it and there is some DIY ? BTW. I've done such job on some other cars long time ago this one will be something new for me, so, I have some basic knowledge but any tip woll be appreciated |
Bookmarks |
|
|