[A4rings]

whats up guys, i turned my 335i on today and found nice red exclamation mark on my dash. I scrolled through the menus and saw a symbol of my car on a lift that was illuminated red. Prior to this I had gotten several o2 sensor codes which caused a (service engine soon) light. as well as some "short circuit codes"

E18C:
Device didn't accept or confirm monitoring message (Error_Monitoring)
Error will not cause a warning light
Error is not currently present
Test conditions have been completed


MSD80/MSD81 Engine module for N54
Current Fault Codes

2C2E:
2C2E Lambda probe in front of catalytic converter 2, thrust control
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption
2C3E:

2C3E Lambda probe in front of catalytic converter 2, control failure or cable transmission failure?
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Timeout
Freeze Frame Information
Odometer 42200kms 26221miles
suction pipe pressure 25.00 kPa
voltage Lambda probe in front of catalytic converter bank 2 2.77 V
symptom bei Schubabschaltung Sonde in front of catalytic converter bank 2 1.00 0-n
ceramic temperature Lambda probe in front of catalytic converter bank 2 0.00 °C

29D2:
29D2 Misfirings, cylinder 6
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption


2FCA:

Error will not cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

2FDA:

Error will not cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

2FDB:

Error will not cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

29D2:
29D2 Misfirings, cylinder 6
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

Now the manual says:

Starter failed or ignition malfunctioning or lighting system failed. None of these things seem to be the problem. Im thinking maybe i did something wring the last time i installed the procede. Do you guys have any idea what these "short circuit or signal interruption" codes are for?

[username604]

well i don't know anything about all those codes.. but i think that means its time for the scheduled check up.. (maintenance) I'm just going by the pics i saw on my idrive

edit: its red, so i guess its not maintenance, sorry bout that

[jaguar36]

Did you replace the O2 sensors when you got the code previously?

[shockin330i]

My friend is looking into a car and the car has the same lights. 09 335xi

[A4rings]

it ended up just being a vehicle inspection