|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Code reading
|
|
07-29-2012, 02:48 AM | #1 |
New Member
1
Rep 17
Posts |
Code reading
Guys,
Anyone know a quick way to read the ECU codes on a 330d. I have used the likes of VAG Com when I have Audis. I think I got a bust injector. Lumpy tick over, loud ticking from engine and a bit slow to 2000 rpm. Any ideas how to find out what's wrong? |
07-31-2012, 06:03 AM | #3 |
New Member
4
Rep 16
Posts |
I have always used INPA on my BMWs. I also use DIS/GT1 if you want your diagnostics a little more detailed. Usually INPA is sufficient.
Contact 'jimmy' on www.bmw5.co.uk, tell him I sent you
__________________
Last edited by WNeill; 08-03-2012 at 04:58 AM.. Reason: spelling |
Appreciate
0
|
07-31-2012, 06:45 AM | #4 |
Colonel
147
Rep 2,048
Posts |
there are a few cables you can buy
BT - Bavarian Technic - which I think you can buy from overseas only (pm neil@juiced tuning) yu can buy leads off ebay that come with software - INPA/DIS (latter pain to install) whchi will give you the ability to read and clear codes Last edited by mistryn; 07-31-2012 at 07:18 AM.. |
Appreciate
0
|
07-31-2012, 07:18 AM | #5 |
First Lieutenant
26
Rep 306
Posts |
I have recently purchased a cable off eBay with the software and can vouch for them being a pain in the arse to install and use.
However I have successfully done it, and have cleared codes after recently changing some parts on my car. |
Appreciate
0
|
Bookmarks |
|
|