|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
BMW E92 Rear Bumper - Question
|
|
08-24-2012, 06:04 PM | #1 |
First Lieutenant
83
Rep 353
Posts |
BMW E92 Rear Bumper - Question
Hi,
Well I am doing my PDC front and rear modification and while removing the rear bumper I ended up breaking 3 tabs as shown in the below pic. Will I be able to hold it in place or now i need to invest in a new rear bumper or is there a fix. Any help on this is greatly appreciated Thanks Ramez
__________________
15 F06 640i xDrive Gran Coupe/Grey
|
08-24-2012, 09:35 PM | #2 |
Colonel
40
Rep 2,431
Posts |
Just use some fiberglass to repair the clips and you'll be fine.
__________________
My speeding isn't the problem. It's the Slow Folks ahead of me that cause accidents!
|
Appreciate
0
|
08-24-2012, 10:19 PM | #3 |
First Lieutenant
83
Rep 353
Posts |
ChasVS, i never did that before. Can you tell me more about it?..... Is that something I buy from like Autozone, etc
thanks
__________________
15 F06 640i xDrive Gran Coupe/Grey
|
Appreciate
0
|
08-25-2012, 07:43 AM | #4 | |
Colonel
40
Rep 2,431
Posts |
Quote:
Just cut the fiberglass sheets to fit the edges you broke and follow the instructions on the kit on mixing the resin and coating the fiberglass. It sets up and cures in a short period. Then just a little trimming and sanding to ensure the clips fit and you're done. Worst case if it doesn't work for you is you buy a new bumper, but I'm sure you can fix it with the Fiberglass kit.
__________________
My speeding isn't the problem. It's the Slow Folks ahead of me that cause accidents!
|
|
Appreciate
0
|
Bookmarks |
|
|