|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
headlight washer cover
|
|
05-20-2014, 12:44 PM | #1 |
Enlisted Member
1
Rep 33
Posts |
headlight washer cover
Had a little incident with the car and the headlight washer cover has come off, i still have the cover and it has two springs attached to it, its just im a little unsure how to get it back on.
Any help? |
05-20-2014, 01:04 PM | #2 |
Major
103
Rep 1,184
Posts |
yup i had this problem!
basically, pull the springs off the plastic piece which goes on the actual washer jet... then you twist the big end of the spring into the holes in the washer cover... use your finger nail to separate the last coil of the spring and twist it in.... then after just clip the springs back into the plastic piece and then clip that onto the washer jet.... (i found it helped to use pliers to stop the washer going back in while i clipped the cover into place).... hope i helped!
__________________
PAST: 2007 E93 335i 6MT NOW: 2012 F10 M5 Facebook: Achu Ckr|Twitter: AchuCkr|Instagram: AchuCKR|Flickr: AchuCKR|G+: achu.ckr THE BUILD THREAD|COMPILATION OF PHOTOS |
Appreciate
0
|
05-20-2014, 01:06 PM | #3 |
Major
103
Rep 1,184
Posts |
oh wait, just read the washer cover still has the springs on it? in that case just pull out the washer jet with you hand and pull off the clip... then just clip it onto the springs
__________________
PAST: 2007 E93 335i 6MT NOW: 2012 F10 M5 Facebook: Achu Ckr|Twitter: AchuCkr|Instagram: AchuCKR|Flickr: AchuCKR|G+: achu.ckr THE BUILD THREAD|COMPILATION OF PHOTOS |
Appreciate
0
|
Bookmarks |
|
|