Pic request. Spacer related

[monterey]

Anyone got a pic of a stock height car with wheel spacers that push it out flush?

[leopard print]

http://www.m3post.com/forums/showthread.php?t=262054

[///MPower15]

Stock ZCP height, 15mm front 12mm rear, 245/275 tires. Perfectly flush, just needs a drop

[Rat3d ///M]

same setup I have. perfect imho

[hpapad01]

Originally Posted by ///MPower15

Stock ZCP height, 15mm front 12mm rear, 245/275 tires. Perfectly flush, just needs a drop

What type of wheel studs to you have?

[yidgyi]

Originally Posted by ///MPower15

Stock ZCP height, 15mm front 12mm rear, 245/275 tires. Perfectly flush, just needs a drop

Holy shit I found my exterior twin. We even have the tire rub marks!

[///MPower15]

Originally Posted by hpapad01

What type of wheel studs to you have?

Apex studs. I don't recommend them. They rusted inside in the hex head in less than 1 month. I told them about it and it took them two weeks of back and forth to tell me its normal and they won't do anything about it. Maybe their bullet nose studs are better.

Originally Posted by yidgyi

Holy shit I found my exterior twin. We even have the tire rub marks!

Pics or its not true lol

Do you know why those tire marks happen? I plan on lowering so I'm guessing the rubbing will get worse. I think my alignment is wack so I was hopping getting that done will fix it.

[yidgyi]

It's rubbing against the wheel housing. (black plastic above tire.) That's the issue for me. I have 265/35/19" 295/35/19" stock ZCP height. Take out your wheel and inspect the wheel housing for rub marks. You will find where it hits. My main issue with it is that my rear tire when hitting a bump hits the part where the rear bumper and side panel wheel arch connect. Kind of pointy but not for me anymore because my tires shaved it off.

[///MPower15]

Originally Posted by yidgyi

It's rubbing against the wheel housing. (black plastic above tire.) That's the issue for me. I have 265/35/19" 295/35/19" stock ZCP height. Take out your wheel and inspect the wheel housing for rub marks. You will find where it hits. My main issue with it is that my rear tire when hitting a bump hits the part where the rear bumper and side panel wheel arch connect. Kind of pointy but not for me anymore because my tires shaved it off.

That's what I thought. I was hoping the liner will trim down but it hasn't yet. Might just sand it down lol.

[Denk]

10mm square, stock ZCP suspension/tire sizes. I like it, just enough for me with zero rub at full compression lock to lock.

[monterey]

Looks good. Ok I'm convinced.

[kb9uwu]

Originally Posted by monterey

Anyone got a pic of a stock height car with wheel spacers that push it out flush?

i'm running 12.5mm spacers in the rear and none up front on my stock car, love the look! (sorry no pic, just $0.02)

[monterey]

Originally Posted by kb9uwu

i'm running 12.5mm spacers in the rear and none up front on my stock car, love the look! (sorry no pic, just $0.02)

I was considering that as well. snap a pic if you can. thx

[kb9uwu]

Originally Posted by monterey

I was considering that as well. snap a pic if you can. thx

Here you go, just shitty cell phone picture from work parking lot.

no spacers up front, 12.5mm rear, everything else stock

[Thik]

Originally Posted by monterey

Anyone got a pic of a stock height car with wheel spacers that push it out flush?

18mm spacer in the rear, none in the front.